YQ(Y)W series gas-fired/oil-fired thermal oil boilers have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.
This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).
YQ(Y)W Series Gas/oil fired Thermal Oil Heater WUXI ZOZEN BOILERS CO.,LTD. , https://www.cnzozen.com
Stable arc, beautiful welding surface and easy operation.
Current can be adjusted by food control.
Minimizing, lightness and low noise.
Be able to weld mild steel, stainless steel, copper and Titanor metal etc., by DC function. Also be able to weld aluminium and aluminium-alloy by AC function.
Power supply: 3X380V~440V 50/60Hz
Input Power: 6.3KVA
No load Voltage: 54 Current Range: 20~250A
Duty Cycle: 60% Pre-flow(S): 0~2s
Gas post flow time: 2~10s Down-slope time(S): 0~5
SP Value(Balance): 20~80%
Max welding thichness with AC(mm): 5
Category Name
Subcategory Name
Active
Length
Width
 Height
 Weight
MMA / TIG Machines
TIG AC/DC Machines
1
580
334
480
38
Stable arc, beautiful welding surface and easy operation.
Current can be adjusted by food control.
Minimizing, lightness and low noise.
Be able to weld mild steel, stainless steel, copper and Titanor metal etc., by DC function. Also be able to weld aluminium and aluminium-alloy by AC function.
Power supply: 3X380V~440V 50/60Hz
Input Power: 6.3KVA
No load Voltage: 54 Current Range: 20~250A
Duty Cycle: 60% Pre-flow(S): 0~2s
Gas post flow time: 2~10s Down-slope time(S): 0~5
SP Value(Balance): 20~80%
Max welding thichness with AC(mm): 5
Category Name
Subcategory Name
Active
Length
Width
 Height
 Weight
MMA / TIG Machines
TIG AC/DC Machines
1
580
334
480
38
Model NO.: WSE250
Origin: China
HS Code: 85153900
Model NO.: WSE250
Origin: China
HS Code: 85153900
INVERTER ACDC TIG/MMA WELDING MACHINE WSE250