Chengyue Pump specializes in producing biogas digester pump

Biogas pumping slag pump consists of pump body, rotor, front and rear end covers, blades, bearings, couplings and other components. The center of the rotor is paranoid to the center of the pump body. When the biogas pump is working, the power taken by the pulley or the power take-off device passes through the shaft. The rotor in the rotor eccentrically rotates the air in the sealed tank to form a negative pressure and utilizes atmospheric pressure. The difference between the pressure of the air in the tank and the air is sucked into the tank to achieve the purpose of collection and transportation.

The biogas pump can be installed on farm tractors, tractors, agricultural tractors and large trucks. It is a choice for sanitation suction trucks, urban sewage suction trucks, and oil trucks.

Operation steps and application principle

1. When the clutch is pushed up, the methane pump is rotated and it is ready to start pumping.

2. Insert the tank's upper tube into the tank.

3. Turn the four-way valve to connect the liquid tank to make the air pumping line open, and start the suction operation.

4. When pumping biogas slurry, the elevation of the fluid level at the sight glass of the tank should be observed. When the liquid level reaches a certain height, the pressure relief valve should be quickly opened to relieve pressure or close the control valve, and the gas path should be disconnected to make the container and Biogas pumping pump system disconnected.