Hydraulic metal machine is mainly applicable to steel mills, recycling and processing industries and non-ferrous metal smelting industries. Hydraulic Baling Machine can squeeze all kinds of metal scrap (steel shaving, waste steel, waste aluminum, waste copper, waste stainless steel and scrap automobile waste, etc.) into cuboid, octagon, cylinder and other shapes of qualified charge, which can reduce the transportation and smelting cost, and improve the speed of furnace. It is mainly used for cold pressing under normal conditions for scrap metal scraps, scrap steel scraps, waste oil tank, disassembling car shell and other metal scraps with a thickness of less than 3mm. Cold pressed into blocks for easy storage and transportation or furnace.
Features:
1) Hydraulic drive, smooth and noiseless work, fast extrusion speed, large extrusion force, compact package block, not easy to be scattered.
2) high quality national standard steel plate with advanced welding technology to make the mechanical parts strong and durable, low failure rate, long service life.
3) the oil cylinder seal is imported glyd ring, good sealing performance, strong pressure resistance.
4) Convenient installation, small floor space, no foundation, foot, etc. Simple operation, detachable and PLC automatic mode.
5) Cold extrusion will not change the metal material and increase the utilization rate.
Metal Shavings Baler, Scrap Metal Baler, Waste Metal Baler, Sheet Metal Baler, Metal Scraps Baler Jiangyin Metallurgy Hydraulic Machinery Factory , https://www.ecometalsrecycling.com
The method of dismounting the rolling bearing is similar to that of disassembling the pulley, and it can also be performed using a puller. If there is no puller, you can use two iron poles to clamp the shaft, so that the rotor is vacant. Then, after the wooden end or the copper block is attached to the upper end of the shaft, use a hammer to knock off the bearing and remove it. Pay attention to safety during operation. During assembly, you can find a flat iron pipe with an inner diameter slightly larger than the outer diameter of the shaft and insert it into the shaft so that the pipe wall just abuts on the inner ring of the bearing. Then the wood block can be tapped with the hand hammer to make the bearing fit in. Rotor location. Note that the inner circle of the bearing and the shaft cannot be too tight. If it is too tight, the surface of the shaft can be turned around with a fine emery cloth and evenly polished so that the general tightness can be maintained after the bearing is inserted. In addition, the outer ring of the bearing and the end cap must not be too tight.