Constant temperature and humidity test chamber The dry filter is located between the condenser and the capillary tube. It is mainly used to absorb foreign substances such as residual moisture, dust, and metals in the refrigeration system to prevent the impurities and moisture in the refrigerant from entering the capillary and thus producing ice. Blocking, dirty plugging and other faults cause the cooling system to fail to operate properly. Once the filter dries up, how can this be solved?

The general dry filter failure recommendation is to replace the new filter, without a new filter and then carry out a simple activation process, remove the filter, soak in clean gasoline, so that after the dirt is fluffy, then tap the filter At the periphery of the device, dirt will fall off, and then it will be repeatedly cleaned in gasoline and then removed. Then use dry nitrogen to repeatedly blow the two ports of the filter, and then continue to clean it repeatedly in clean gasoline.

The removal of the dry filter needs to be handled by a professional because it requires a specific oven and technology. After removing the filter, place the port under the lamp to observe any dirt. After confirming the cleaning, place it in the oven, raise the temperature to 200 degrees, continue baking for more than 4 hours, and then remove it. Repeat the flush with dry nitrogen from both ends and bake it in the oven for 2 hours. Wait for the oven to cool naturally to room temperature and take it out again. Before removal, the two sides of the filter must be sealed with soft plugs in the chamber so that the filter can be reused.

T-head Bolts

T-Head Bolts,T-Bolt Screws,T-Bolt Fasteners,T Head Bolts

Suzhou Chenran Precision Fasteners Co., Ltd. , https://www.chenranhardware.com

Posted on