Refinement, cold work, strict quality control

More than 2:00 in the afternoon, the sun was shining high and the temperature reached 35 degrees. Next to the reservoir where the water pressure was adjusted, the technicians and commissioning personnel of the road machinery were standing by the sun and adjusted the water pressure of 550N over and over again.

German workers cold recycling strict quality control

German workers cold recycling strict quality control

Recently, the market demand for cold recycling machines for the German roads has been continuously expanding, production is in short supply, and customers are also in a hurry to have cars. However, the production and technology department of cold recycling holds a principle that customers must be eager to get cars, and they must also ensure the All technical indicators can be submitted to the customer only after passing the inspection. The 550N is being debugged. During the commissioning process, the pressure in the sprinkler section was found to be 38 cubic meters per hour, and our technical requirement was 40 cubic meters per hour. The commissioning staff provided feedback to the technicians in a timely manner, and the technicians immediately went to the site to check.

Check whether the control part is normal on the vehicle, whether there is leakage of water leaks in the pipeline and the joint part of the vehicle inspection. The technicians and commissioning personnel go on the train over and over again, get off the car and check every possible problem part, carefully over and over again. Debugging finally found the problem and ruled out the problem. Look at the table is already 5 points faster. Although the clothes had been wetted by sweat, the troubleshooting equipment passed the test and several technicians still showed a happy smile on their faces. (This article comes from German workers)