Fully Hydraulic Jumbo Drilling Rig Underground tunneling mining drilling rig machine
1.Rugged and reliable
Tunnel Drilling Machine,Channel Tunnel Drill,Tunnel Boring Drill,Channel Tunnel Drilling Machine JIANGSU XI TEC ENVIRONMENTAL&DRILLING EQUIPMENT COMPANY CO.LTD , https://www.xitecdrillingwx.com
　　
â‘ pump output power (liquid power) ruler = pieces <3? / 1000;
　　
â‘¡ shaft power (prime mover to the shaft power) P;
　　
â‘¢ prime mover power Pgr.
　　
Pump efficiency 7 = Pe / P; unit efficiency% r = PeAPgr.
　　
Prescribed point: refers to the specified pump design and manufacturing given speed, flow, head, shaft power, NPSH and efficiency values ​​corresponding to the operating point. The parameters corresponding to the specified point are the specified parameters.
　　
Pump working range: refers to greater than and less than the specified flow (or head) between the value of a certain range. Large flow point refers to the working area is greater than the specified flow boundary point; small flow point is the working area is less than the specified flow boundary point.
　　
Horizontal centrifugal pump standard test device requirements
　　
All effective measures must be taken to ensure that the liquid passing through the measuring section has the following characteristics:
　　
â‘ Axisymmetric speed distribution;
　　
â‘¡ isostatic pressure distribution;
　　
â‘¢ no device caused by the vortex.
　　
For standard test circuits, the length of a straight pipe from a tank with a free surface or into a large container with a stationary surface in a closed circuit, and the diameter of the pump inlet, etc., is defined as:
　　
â‘ If the inlet throttle valve has been kept fully open, the length of the straight pipe of the diameter of the case, port and other ports shall not be less than 7D (D is the diameter of the pump and outlet pipes);
　　
â‘¡ If the population throttle at any opening state, and the diameter of the pump inlet straight pipe length of not less than 12D;
　　
â‘¢ standard test device, and the pump population diameter equal to straight pipe length of not less than 4D (C grade) or 5D (B grade).
　　
Horizontal centrifugal pump simulation test device requirements
　　
If the pump is to be tested under simulated field conditions, it is not advisable to set the rectifying grid immediately in front of the pump. The flow characteristics of the analogue loop should be controllable, the flow should be as free from vortex as possible and have a symmetrical velocity profile. When necessary, the test tube shall be used to determine the velocity distribution of the simulated circuit to verify that the flow characteristics meet the requirements. If not, a suitable device such as a rectifier grid can be provided to obtain the required flow characteristics, but it must be ensured that large pressure losses will not occur in the test conditions.
3. Safe,roof ROPS and FOPS approved
4. Heavy duty and verrsatile boom means direct,fast and accurate positioning
5.Feed rotation unit with 360 degrees rollover and 360 degrees rotation,could drill side doors and bolting holes
6.High performance with reliable hydraulic control system,ergonomically designed operator environment,good visibility and hand reach servicability on the panel
7.Heavy feed and rotation rock drill designed for any face condition
8. Operation friendly for easy drilling and tramming
9.Main application:
9.1.Hard rock blasting holes drilling
9.2.Tunnelling
9.3. Mining
9.4.Hydropower projects
9.5.Compact hydraulic station
9.6.The radiator for drilling machine can reduce the oil temperature efficiently to avoid hydraulic 9.7oil from changing to low viscosity or destroyed because of the very high temperature of oil.
9.8.The electric control box can protect the electric motor to operate safely.
Horizontal centrifugal pump power requirements: