Industrial flammable gas detection instrument management specification stipulation Purpose: In order to regulate the company's flammable gas detection during production and inspection, and ensure the safety of operation, this regulation is formulated. Its main scope of application: It applies to inflammable and explosive places throughout the company, and the gas content in the limited space is tested. First, industrial combustible gas detection testing equipment: 1. Manufacturers of fixed (or mobile) detection devices and instruments have corresponding qualifications (including production licenses for measuring instruments, explosion-proof apparatus, etc.). 2. The device (instrument) has high sensitivity and is affected by temperature, humidity, and other gases. 3. Qualified by the national or local quality and technical supervision department. 4, before the first use according to the instructions or relevant technical data regulations, check the instrument is normal, to be confirmed in normal working condition, before starting testing. 5. After the test is over, review the correctness of the instrument again to prove that the instrument is in a normal state during the whole process of detection. Second, the industrial flammable gas detector management regulations require testing personnel: First of all, the testing personnel must undergo professional training and obtain corresponding qualifications. Secondly, when the test was conducted, a two-person work system was adopted, one test and one guardianship. When carrying out the test again, the test personnel shall be on fire and wear protective clothing. Third, the industrial combustible gas detector test specifications specified by the test procedure: 1. Limited space, flammable and explosive areas Close the relevant pipelines and valves and maintain natural ventilation. If the effect is not good, perform mechanical ventilation and keep it for more than 2 hours. 2. After the implementation of the provisions in Article 5.1, the person in charge of the job site shall apply to the production safety management personnel and the production department shall arrange for the personnel to inspect. 3. After the inspection personnel receive the task, they must understand the hazard characteristics of the gas, the structure of the tested equipment and facilities, and must not enter when they do not understand the situation. 4, confirm the detection point, require the upper, middle, lower or before, in and after a total of three points, the maximum number of points per point record. IV. Issuance of test reports regulated by the regulations for the management of industrial combustible gas detectors 1, each test is completed, test personnel to issue a test report. Accurately fill in the test data. 2. Testers must have their signature on the test report, otherwise they will be invalid. Fifth, industrial combustible gas detector management specification provides maintenance and repair: The test report can only prove that the current period of the test equipment (facility) is in a safe state, and it cannot guarantee that the test will remain unchanged for a long time. Therefore, whether to perform the next test and its time period must be considered. Curico Tips: Equipment and facilities are in maintenance state, and natural (or mechanical) ventilation measures are still required after passing the test. Strength Equipment,Gym Equipment,Strength Training Equipment,Hammer Strength Machine Foshan Laijian Fitness Equipment Co., Ltd. , https://www.laijiangymequipment.com