A few days ago, the Ministry of Environmental Protection stipulated that starting July 1, 2013, all heavy-duty vehicle compression ignition engines produced, imported, sold, and registered should be mainly referred to as diesel engines and must comply with the “National IV” emissions issued in 2005. Standard requirements.

In large cities, due to heavy-duty diesel trucks being banned from entering the center of the city during the day, people's concern about their pollution is not high. However, according to the "2012 Annual Report on Motor Vehicle Pollution Prevention and Control" issued by the Ministry of Environmental Protection at the end of last year, the number of diesel vehicles that accounted for 17.4% of the total number of motor vehicles was 3.887 million tons of nitrogen oxides and 5.9 million particles (PM). Tons, their emissions accounted for 67.4% and 99% of the total vehicle emissions. According to the China Environmental Quality Bulletin, the total amount of nitrogen oxides emitted in 2011 was 24.04 million tons, that is to say, only one nitrogen oxide, diesel vehicles accounted for about 16%.

Hu Jingnan, an associate researcher at the Chinese Academy of Environmental Sciences who has long been engaged in the study of motor vehicle pollution control, believes that due to the lack of relevant research data, the annual report did not fully incorporate particulate emissions from gasoline vehicles. Therefore, the proportion of diesel vehicle emissions has been enlarged. Even so, it is an indisputable fact that the proportion of nitrogen oxide emissions from diesel vehicles exceeds 60% and particulate emissions approach 90%.

Nitrogen oxide itself is toxic, and it is also one of the main sources of acid rain, and the nitrogen oxides emitted by automobiles can easily become precursors of PM2.5 and ozone. After a complex chemical change, the harm to human body is very great.

According to the National IV standard, the emission of nitrogen oxides will be reduced from 5.0 g/kWh at the national level to 3.5 g/kWh. The particulate emission limit will be reduced from 0.10 g/kWh to 0.02 g/kWh, which is also known as nitrogen oxides. With 30% emission reduction and 80% reduction of particulate matter, the environmental benefits are very obvious. Hu Jingnan said that if this is the case, if the new national standard can be fully implemented, only the nitrogen oxide reduction will reach about 180,000 tons/year.

In the eyes of scientific researchers, the implementation of the National IV standard is a milestone in the prevention and control of diesel vehicle pollution, not only because of the drastic reduction in pollutant emissions, but also in the leap of pollution control technology. “From State II to State III, it is from mechanical control to electronic control. From State III to State IV, we must not only have an electronic control system, but also a post-processing technology system.” Hu Jingnan introduced this post-processing system, usually Known as SCR technology, which is currently the most selective catalytic reduction technology for power plant denitrification, its application has made a qualitative leap in diesel engine emission reduction. At the same time, after the emission standards were upgraded to National IV, heavy-duty diesel vehicles could reduce fuel consumption by about 5%, and the power increase was about 10%.

Although the fourth national standard for heavy-duty diesel vehicles was implemented on July 1, the National IV standard has only been implemented in half. Due to the lack of fuel that matches the emission standards, the implementation time of the National IV emission standard for light-duty diesel vehicles has been delayed again. In the face of serious concerns about the quality of the atmospheric environment today, how to better promote the emission standards of diesel vehicles continue to advance, absolutely not slack.

Recalling the upgrading process of diesel vehicle emission standards, Hu Jingnan was very impressed. The Fourth National Standard was introduced in 2005, leaving time for the planned implementation in 2010. However, when it comes to the 2010 implementation deadline, not only can the fuel quality of vehicles be kept below the standard, but also the level of technical reserves of domestic diesel engine manufacturers is not enough. To implement the national standard, the cost of each vehicle must increase by 40,000 to 50,000 yuan. This is obviously Both manufacturers and consumers find it difficult to accept. However, due to the pressure brought about by the implementation period of the standard, at the same time, the manufacturers saw the fuel-efficient benefits of technological upgrading, the technological transformation was speeded up, and the production capacity of related equipment quickly matured. By 2012, to achieve the National 4 standard, the cost increase for each car will be reduced to around 10,000 yuan.

However, when technology and markets are ready, the standard has been postponed twice. In the final analysis, the quality of oil products has been tampered with. Since the light-duty diesel vehicle's post-processing device is sensitive to the sulfur content of the oil, the 350-ppm three-phase diesel fuel currently available on the market cannot meet its needs.

Penguin Diffuser

Aroma DiffuserOil DiffuserAir DiffuserElectric Diffuser

The weather in the south is cold and humid, the pores are tightened, and the blood circulation is not smooth, so it is difficult to show a healthy complexion. Therefore, it is of great benefit to have a moderate facial massage after washing your face every time. From top to bottom, spiral from inside to outside, massage the face for a few minutes can accelerate blood circulation, warm the skin, expand pores, discharge old epidermal cells, and restore ruddy and healthy facial skin. This method can also improve the skin's resistance to cold. When massaging, pay attention to the cleanness of hands and gentle manipulation.


Winter bath tips:

If you don't want to see your skin haggard and dry next spring, you'd better take active action this winter and take advantage of bathing "beauty body"!

Alternate hot water bath: a simple way to enjoy a sauna at home. Flush with hot water with a water temperature of about 40oC for 2 ~ 3 minutes to warm the body, and then flush with cold water with a water temperature of about 17oc for 2 ~ 3 minutes. If you feel that the temperature difference is too large and you are not used to it, you can make the cold water temperature a little higher at first. Flush the body with the above hot water and cold water alternately for five times, and finally flush the body with hot water to feel smooth and comfortable.

There is no doubt that getting up in the morning in winter is "reluctantly", and the body generally feels a little stiff. Using the morning bath to clear your mind and stimulate your muscles can inadvertently make your mind clear and cool and start a happy day. The shower is 20 ~ 30 cm away from the face. Gently rinse it with cold water for five or six minutes, which not only helps to clear your mind, but also makes it easier to put on makeup. Late bath can eliminate nerve and muscle fatigue. In order to avoid over stimulating the skin, the water temperature should be kept between 38 ~ 40 degrees. Proper use of puffs can promote blood circulation and remove dead skin.



There are four commandments for skin care in winter

In winter, when the cold wind blows and the weather is dry, it will make dry skin more likely to lose moisture unknowingly. In the process of skin care, avoid the following skin care procedures:

(1) Use strong degreasing cleanser: especially for dry skin, use mild cleanser or soap containing oil.

(2) Wash your face with hot water: hot water has strong degreasing power. Wash your face with hot water to wash away the skin oil. Water is easy to lose, and the skin is more dry and itchy.

(3) Indoor temperature is too high: when the indoor temperature is too high, the indoor relative humidity will drop, and the skin moisture is easy to lose.

(4) Dry body immediately after bathing: it is not suitable to dry your face and body with a towel after bathing. Take a bath in cold weather. When you leave warm water, everyone will quickly dry their body and put on clothes. However, to prevent skin dryness and itching, you should apply moisturizing oil and moisturizing lotion to keep moisture in the dry half of your body.

The doctor suggested that an Aroma Diffuser should be placed indoors, which can effectively and immediately solve the problem of indoor air drying, humidify the air and solve the problem of air drying. For the ultrasonic aroma diffuser, the fog is sprayed out through vibration. You can contact us to learn more about aroma diffuser

Penguin diffuser humidifier, Wifi scent diffuser machine, Ultrasonic scent diffuser, Aroma diffuser wood, Luxury diffuser bottle

Shenzhen Ewong Technology CO.LTD , https://www.ewongteches.com

Posted on