2. When the ruptured tubing ruptures, the tubing can be wiped clean, coated with soap, wrapped with a piece of cloth or tape around the broken tubing, and tied with wire, then coated with soap. 3. When the tubing breaks off the tubing, it is possible to find rubber or plastic tubings that fit the diameter of the tubing. If the socket is not tight enough, the two ends are tied with wire to prevent oil leakage. 4. Cylinder head appears with sand eyes and oil leakage, leakage can be based on the size of the trachoma, use the appropriate specifications of the electrical fuse, the hammer gently into the trachoma, you can eliminate oil leakage, leakage. 5. When oil pipe joints are used in oil spill vehicles, such as engine oil pipe joints leaking oil, most of the oil pipe bell mouths and oil pipe nuts are not sealed. The cotton yarn can be wrapped around the lower edge of the horn, and the tubing nut and tubing connector can be tightened. The bubble gum or maltose can also be chewed into a paste and coated on the tubing nut seat. After sealing, it can be sealed. 6. The diaphragm or the diaphragm of the oil pump ruptures or breaks. The oil pump can be taken out and the diaphragm can be taken out. The diaphragm can be formed with a plastic board, an electrician insulating bakelite or a plastic cloth according to the original shape and size, and be polished and mounted. 7. After the valve spring is broken and the valve spring is broken, the broken spring can be removed, and the broken two sections can be installed in reverse. You can also find a piece of 1 mm thick sheet metal, cut into 1 mm larger than the spring diameter of the disk, cut a round hole inside, the diameter is less than the spring diameter of 4 mm, the outer edge of every 6 mm into a 4 mm long slit, cut After every good one piece is folded one by one to form a double-sided spring seat groove, and then the spring turn head can be used in the tin groove. 8. When the inlet and outlet hoses are not broken and ruptured, use a cloth coated with soap to wrap the leaks. If the cracks are large, the hoses can be cut off and a bamboo or iron pipe can be placed in the middle. Wire tied. 9. Breaking the fan belt can tie the broken belt with iron wire or open the car to drive away. 10. Screw hole sliding screw hole slider will cause oil leakage or loose link, making it unable to work. At this time, the original screw can be flattened with a hammer, so that the expansion of both sides of the expansion and then tightened, but not dismantled many times, to be repaired when the next maintenance. Polyethylene Glycol,Polyethylene Glygcol,Poly Ethylene Glycol,Polyethylene Glycol Series Jiangsu Zhongluman New Material Technology Co., Ltd , https://www.zjrozhmch.com
1. Damage to the fuel tank When the vehicle is in use, it is found that the oil leaks from the fuel tank. You can clean the oil spill, apply soap or bubble gum to the oil leak, temporarily block it, and repair it with an epoxy resin adhesive.