Tyre protection chain installation method

Tire protection chain

A tire protection chain for a vehicle has a chain link, a main body chain member connected between the chain links, a side chain connecting the two side link rings, and a docking chain member connected to the both end chain links, and two links are mounted on both sides. A fastening rope with a rope card at the end, the main chain member is of an open type, and a reinforcement pin is fixedly installed at its opening. Because the reinforcement pin and the main chain member are fastened on both sides, the top beam functions, and the chain opening is not easily deformed. Therefore, the utility model has low breakage rate and long service life. Tire protection chain adopts domestic and foreign advanced production technology, uses high-quality alloy steel materials, precision casting, high-strength automatic flash butt welding, reasonable structure, use of special welding process welding, good wear resistance, fatigue resistance, according to Use conditions of life of 3000-8000 hours. Easy assembly and disassembly, saving time and labor, complete product specifications, matching with imported loaders, tire protection chain, using high-tech wear-resistant materials made of novel and compact structure, stable performance, mainly applicable to the loader of mining operations, The tires wear fast, the service life is short, the tires are expensive, and the use cost is high. The product is tightly wrapped on the tires of the loader, which can effectively protect the tires of the loader, and is not punctured by the sharp stones, prolonging. The tire's service life, using a tire protection chain, can save ten tires and more, but also improve the loader's working efficiency and safety is a must for mine operations.

installation method

Required tools: hammer, pliers, wire (about 1 meter)

1. Place the loader in a flat area and release the tire air by about one-third.

2. Unfold and lay the chain in front of the tires that need to be installed (inside and outside).

3. Remove the fittings (opening section and diamond-shaped opening section), and use one meter of wire to hang one end of the chain.

4. Turn on the loader and note that the front of the tire is aligned with the front of the chain.

5. Use a wire to hang the pattern of the tire, use a crowbar to straighten the chain, and slowly move the vehicle backwards until the protection chain is wrapped around the tire (front and rear).

6. After both ends of the chain are aligned, connect the two ends with a connection section.

7. Connect the tightening chain outside the tire and tighten and tighten it.

8. Inspect the locking ring of the entire tire protection chain so that the welding port faces outward to avoid wearing the tire.